Englishen españoles
Alkaline Water Pitcher

Ionized Water Machine

home |Ionized Water Machine |

How to install a multifunctional water ionizer?

How to install a multifunctional water ionizer?

  • 2020/10/14
1. Check The Accessories
Before installing the machine, please check if all the accessories are received. If any of them missing, please contact the distributor/seller.

Note: If there is any improvement, it will be clarified in this manual. The product’s appearance, color changes and specifications are subject to modification without notice.

2. Installation Environment
A. Install the machine in a place where avoid the direct sunshine and the fire (Over 1 Meter).
B. This water ionizer is using 110V/220V power supply. Please connect it to a separate power socket, and away from other appliances, such as microwave oven. To ensure safety, the ground wire is needed.
C. This water ionizer works with 0.1~0.3MPa water pressure. If your input water pressure is lower than 0.1MPa, please install a booster pump.

3. Installation Tools You May Need
A. Cross Screwdriver
B. Cutter Knife
C. PTFE tape

4. Installation Diagram Overview

How To Connect The Adapter To The Faucet:
Type A:

This type of faucet is with the external threads, after removing the outlet nozzle of the tap. Connect the adapter to the tap and fasten the screw. Ensure the washer has been inserted before tightening.

Type B:

Connect the black rubber part to the faucet. Remove the inside small rubber ring if necessary. Fasten the steel ring with the screwdriver. Then fix the adapter to the screw threads at the bottom of the black rubber part.

How To Connect The Hoses To The Adapter:

Insert the hoses through the hollow bolts first. Fix the hoses on the nozzles, then fasten the hollow bolts.
Top hose (A): Tap water outlet.
Connect the other end to the Pre-filter Inlet. The tap water will flow into the Pre-filter set.
Bottom hose (B): Drain water outlet.
Connect the other end to the Outlet in the back of the unit. The drain water will flow out from the Outlet.

Hoses Installation Diagram:

A 3” soft hose and a 2” hard hose will come with the machine. The 3” soft hose connects the Acid Water Outlet nozzle of the adapter to the water Inlet in the back of the unit. The 2” Hard Hose connects the Hose Converter and the water Inlet in the back of the unit.
And a 3” hard hose will come with the pre-filter set. Cut this Hose into 2 pieces. As shown in the above diagram, one piece connects the Tap Water Outlet nozzle of the adapter and the Pre-filter Inlet. Another piece connects the Pre-filter Outlet and the Hose Converter and 2” Hard Hose.

*Tips: Remove the blue clips on the Hose Converter and plug the hoses inside and push tight. Then put the blue clips back to fasten.
*If you don’t use the pre-filter set, then you need to cut the soft hose into 2 pieces according to your kitchen need. One piece connects the Acid Water Outlet nozzle of the adapter to the water Inlet in the back of the unit. Another piece connects the Tap Water Outlet nozzle of the adapter and the Hose Converter and 2” Hard hose, then to the water Inlet in the back of the unit.

We provide multifunctional water ionizer,alkaline water machine,ionized water filter machine, contact us for more information about water ionizers.

copyright © 2024 CHPIONIZEDWATER.all rights reserved.

top

the professional team to service !

chat now

live chat

    If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!